The procedure and method of using automatic rivet nut gun

Writer： admin Time：2021-08-10 13:42 Browse：

First, the use of automatic rivet nut gun steps

1. Connect the automatic rivet nut gun to the air source:

2, adjust the travel;

3. Align the pull rod of the automatic rivet nut gun with the rivet nut, and then press it gently. The rivet nut will automatically screw into the pull rod and stop.

4. Put the rivet nut into the workpiece:

5, always press the switch, rivet nut will automatically rivet on the work piece and automatically reverse out, and then release the switch, riveting end.

Two, automatic rivet nut gun use method:

1, the left hand rivet nut, the right hand gun, rivet nut on the nozzle, pressure rivet nut will be turned into the rivet nozzle thread.

2, then put the rivet nut into the hole to be riveted, the right hand buckle down the **, pay attention not to loosen, until the riveting place.

3, loosen the screw, the gun nozzle thread rod will reverse, out of the rivet nut.

Three, automatic rivet nut gun adjustment method:

Generally when the factory stroke has been adjusted, if you must adjust the stroke, to adjust the automatic rivet nut gun head on the thread rod of a nut;

If you don't have enough travel, tighten it, if you have too much travel, loosen it.